This is from Wikipedia but shows clearly that fracking has been in use since the 50's in the US - so it would be happening in T2000 as well and they would have the tech for doing it well in place
Massive fracturing[edit]
Massive hydraulic fracturing (also known as high-volume hydraulic fracturing) is a technique first applied by Pan American Petroleum in Stephens County, Oklahoma, USA in 1968. The definition of massive hydraulic fracturing varies, but generally refers to treatments injecting over 150 short tons, or approximately 300,000 pounds (136 metric tonnes), of proppant.[29]
American geologists gradually became aware that there were huge volumes of gas-saturated sandstones with permeability too low (generally less than 0.1 millidarcy) to recover the gas economically.[29] Starting in 1973, massive hydraulic fracturing was used in thousands of gas wells in the San Juan Basin, Denver Basin,[30] the Piceance Basin,[31] and the Green River Basin, and in other hard rock formations of the western US. Other tight sandstone wells in the US made economically viable by massive hydraulic fracturing were in the Clinton-Medina Sandstone, and Cotton Valley Sandstone.[29]
Massive hydraulic fracturing quickly spread in the late 1970s to western Canada, Rotliegend and Carboniferous gas-bearing sandstones in Germany, Netherlands (onshore and offshore gas fields), and the United Kingdom in the North Sea.[28]
Horizontal oil or gas wells were unusual until the late 1980s. Then, operators in Texas began completing thousands of oil wells by drilling horizontally in the Austin Chalk, and giving massive slickwater hydraulic fracturing treatments to the wellbores. Horizontal wells proved much more effective than vertical wells in producing oil from tight chalk;[32] sedimentary beds are usually nearly horizontal, so horizontal wells have much larger contact areas with the target formation.[33]
Shales[edit]
Hydraulic fracturing of shales goes back at least to 1965, when some operators in the Big Sandy gas field of eastern Kentucky and southern West Virginia started hydraulically fracturing the Ohio Shale and Cleveland Shale, using relatively small fracs. The frac jobs generally increased production, especially from lower-yielding wells.[34]
In 1976, the United States government started the Eastern Gas Shales Project, which included numerous public-private hydraulic fracturing demonstration projects.[35] During the same period, the Gas Research Institute, a gas industry research consortium, received approval for research and funding from the Federal Energy Regulatory Commission.[36]
In 1997, taking the slickwater fracturing technique used in East Texas by Union Pacific Resources (now part of Anadarko Petroleum Corporation), Mitchell Energy (now part of Devon Energy), applied the technique in the Barnett Shale of north Texas.[33] This made gas extraction widely economical in the Barnett Shale, and was later applied to other shales.[37][38][39] George P. Mitchell has been called the "father of fracking" because of his role in applying it in shales.[40] The first horizontal well in the Barnett Shale was drilled in 1991, but was not widely done in the Barnett until it was demonstrated that gas could be economically extracted from vertical wells in the Barnett.[33]
|