View Single Post
  #27  
Old 09-13-2017, 03:14 PM
swaghauler swaghauler is offline
Registered User
 
Join Date: Jan 2015
Location: PA
Posts: 1,481
Default

Quote:
Originally Posted by CDAT View Post
Also most of bank trucks are only an armored box, so the engine and all that are not armored, they would be very easy to disable.
This is true of Lights and "Y Bodies" (we call them "squats" because they have very low roofs but are as wide as a "B Body" with a 450 truck front end. About 50% of "B Bodies" have Kevlar "liners" that are attached to the inside of the fiberglass hoods. These would become worn and begin to "detach" from the inside of the hood over time. They would then be removed. The "Super B's" were completely armored (these are also used as SWAT vehicles).

a Light would be AV 1 on every location BUT the engine compartment. The engine compartment is UNARMORED (unless an AV 2 bumper guard is installed at the front).

a Squat/Y Body would have AV 2 on the cargo box and AV 1 on the driver's compartment (NIJ Level 3A Kevlar panels in the doors and NIJ Level 3A Lexan windows). The engine compartment is UNARMORED (unless an AV 2 bumper guard is installed at the front).

a B Body would have AV 2 on the passenger and cargo compartments and NIJ Level 3 (rifle) Lexan windows (AV 2) on a 1-3 (1D10) or NIJ Level 3A (AV 1) on 4-10 (1D10). The engine compartment will have NIJ Level 3A side panels under the fiberglass hood on a 1-5 (1D10) and NIJ Level 2 armored mesh over the front of the radiator (AV 1/2). B Bodies seldom have pushbars/bumper guards because the hood opens forward to the front and they can interfere with the opening of the hood.

a Super B will have AV 2 armor everywhere but the hood. The hood will be MADE of Kevlar at NIJ Level 3A (AV 1) in order to save weight. They also have a large "mesh guard" over the radiator that ups the AV to 2 on frontal hits. Push guards are seldom fitted because the hood opens forward and a guard could interfere with opening the hood.

Run Flat Tires: Unlike military run-flats, these will only reduce the severity of a hit by one level (ie a Major hit becomes a Minor hit) for 100km. After that, the tire must roll OVER its Wear Value or fail.

Self Sealing Fluid/Fuel Systems: These will reduce an engine or fuel hit by one level just like run-flats above. The engine sealing system will allow the engine to run for 100km or 30 minutes on a Major hit and the engine will run for 10 minutes on a Destroyed hit IF a roll OVER its Wear Value succeeds.
Reply With Quote